|
|
|
|
|
|
TOOLPRO 5010 Eye Lag Screw, Carbon Steel, Zinc
|
|
|
Eye lag screws are specifically designed for attaching ceiling grid hanger wire to any wood overhead. The hanger wire is threaded through the eye and twisted off before or after the eye lag screw is installed. Pre-drilling is recommended for the strongest attachment.
|
|
|
|
|
|
|
|
|
|
TOOLPRO TP05044 Ceiling Grid Clamp, Plastic
|
|
|
Lever action grid clamps temporarily connect ceiling grid and firmly hold leveling line during the layout process. Each clamp is made from spring steel and is easy to operate with a single hand. Rubber tips on the clamps hold the grid and leveling line firmly in place without damaging the grid finish.
|
|
|
|
|
|
|
|
|
|
TOOLPRO TP05032 Eye Lag Driver
|
|
|
This heavy-duty tool easily installs eye lag screws up to 4-1/2 in. long as well as self-tapping eye lags screws for metal. Overall length is 2.7 in and will fit any standard size chuck. Use with any drill or driver.
|
|
|
|
|
|
|
|
|
|
TOOLPRO TP05110 Edge Cutter, Steel
|
|
|
The Shadowline cutter creates ideal Shadowline or reveal edges on ceiling tiles and acoustical panels. The one-piece all-steel design is comfortable to hold and use. This contractor-proven tool will not only make the most professional looking cuts possible. It will pay for itself on the first day by eliminating wasted tiles due to bad cuts. Blade changes and cutting depth are easily adjusted by hand with no additional tools required.
|
|
|
|
|
|
|
|
|
|
TOOLPRO 05015 Eye Lag Screw, Carbon Steel, Zinc
|
|
|
Eye lag screws screw into wood ceiling joists to attach hanger wire for suspended ceilings. An eye lag screw is fashioned with an eye for threading the hanger wire and a lag thread on the other end for securing in the wood. Pre-drilling is recommended for the strongest attachment.
|
|
|
|
|
|
|
|
|
|
TOOLPRO TP05060 Grid Punch
|
|
|
This grid punch is the most reliable and economical tool for preparing non-standard lengths of ceiling grid for fastening with rivets. Hardened pin will easily pierce 18 ga steel with little effort, allowing one-hand operation while freeing the other hand to hold the material steady. The tool's thin profile and deep throat makes punching holes into awkward and hard to reach corners possible. For optimum results place the steel cup firmly against the back of the material to be punched and squeeze with consistent pressure, bringing the pin into the material. The rubber tip on the punch will protect painted or coated finishes from being marred.
|
|
|
|
|
|
|
|
|
|
USG DONN SDX/SDXL Series 207535 Hanger Wire, Galvanized
|
|
|
USG DONN SDX/SDXL Hanger Wire, Specifications: Wood Handle, Galvanized, Dimensions: 6 ft
|
|
|
|
|
|
|
|
|
|
TOOLPRO 05122 Ceiling Wire, Galvanized Steel
|
|
|
Hanger wire is used to suspend ceiling grid main tees from the overhead structure. Designed for residential applications. The continuous 300 ft roll lets you cut the lengths you want with no waste.
|
|
|
|
|
|
|
|
|
|
CEILING PNL RADAR SE 2X4X5/8IN
|
|
|
|
|
|
|
|
|
|
|
|
|
TILE CEILING 2X4FT 64SQFT
|
|
|
|
|
|
|
My cart:
